Panasonic NN-CS597S Convection Oven User Manual


 
5
Examine Your Oven
Unpack oven, remove all packing material and examine the oven for any damage such as dents, broken door latches
or cracks in the door. Notify dealer immediately if oven is damaged. DO NOT install if oven is damaged.
Placement of Oven
1. The oven must be placed on a at, stable surface, which is 36" (91.6 cm) height from the ground. Place the front
surface of the door three inches or more from the counter top edge to avoid accidental tipping of the microwave
oven during normal use. For proper operation, the oven must have sufcient air ow. Allow 6" (15 cm) of space
on the top of the oven, 4" (10 cm) at the back, 2" (5 cm) on the left and the other side being open. If one
side of the oven is placed ush against wall, the other side or the top must not be blocked. Do not remove
the bottom feet from the oven.
6" (15 cm)
4"
(10 cm)
OPEN
2" (5 cm)
Counter-top
36" (91.6 cm)
a) DO NOT block air vents. If they are blocked during operation, the oven may overheat and be damaged. Also
allow sufcient space on back and both sides of the oven.
b) DO NOT place oven near a hot or damp surface such as a gas stove, electric range or sink etc.
c) DO NOT operate oven when room humidity is too high.
2. This oven was manufactured for household use only. It is not approved or tested for mobile vehicle, marine, or
commercial use.
Installation
DO NOT block air vents. If they are blocked during operation, the oven may overheat. If the oven overheats, a thermal
safety device will turn the oven off. The oven will remain inoperable until it has been serviced and the safety switch is
reset.
— IMPROPER USE OF THE GROUNDING PLUG CAN RESULT IN A RISK
OF ELECTRIC SHOCK.
Consult a qualied electrician or service person if the grounding instructions are not completely understood, or if doubt
exists as to whether the appliance is properly grounded.
WARNING
INSTALLATION AND GROUNDING INSTRUCTIONS
IP1156_38S70AP_Eng_52_071008.indd Sec1:5IP1156_38S70AP_Eng_52_071008.indd Sec1:5 2007-10-8 @Tom@ 9:58:152007-10-8 @Tom@ 9:58:15