Panasonic NN-SM330W Microwave Oven User Manual


 
- Eng-12 -
English
Before Requesting Service
ALL THESE THINGS ARE NORMAL:
The oven causes interference with my
TV.
Some radio and TV interference might occur when you cook with the microwave
oven. This interference is similar to the interference caused by small appliances
such as mixers, vacuums, hair dryers, etc. It does not indicate a problem with
your oven.
The oven lights dim. When cooking with a power other than HIGH, the oven must cycle to obtain the
lower power levels. The oven light will dim and clicking noises can be heard
when the oven cycles.
Steam accumulates on the oven door
and warm air comes from the oven
vents.
During cooking, steam and warm air are given off from the food. Most of the
steam and warm air are removed from the oven by the air which circulates in the
oven cavity. However, some steam will condense on cooler surfaces such as the
oven door. This is normal and safe. Steam will disappear after the oven is cool
down.
I accidentally operate my microwave
oven without any food in it.
Operating the oven empty for a short time will not damage the oven. However,
we do not recommend this to be done.
PROBLEM POSSIBLE CAUSE REMEDY
For All models:
Oven will not turn on.
The oven is not plugged in securely.
Remove plug from outlet, wait 10 seconds
and re-insert.
Circuit breaker or fuse is tripped or
blown.
Contact the specified service center.
There is a problem with the outlet.
Plug another appliance into the outlet to
check if the outlet is working.
When the oven is turning on,
there is noise coming from
Glass Tray.
The roller ring and oven bottom are
dirty.
Clean these parts according to care of
your oven (See next page).
Oven will not start cooking. The door is not closed completely. Close the oven door securely.
For NN-ST340W only:
Oven will not start cooking.
Start Pad was not pressed after
programming.
Press Start Pad.
Another program has already been
entered into the oven.
Press Stop/Reset Pad to cancel the
previous program and program again.
The program has not been entered
correctly.
Program again according to the Operating
Instructions.
Stop/Reset Pad has been pressed
accidentally.
Program oven again.
The word “Child” appears in
the display window.
The Child Safety Lock was activated
by pressing Start Pad 3 times.
Deactivate Lock by pressing Stop/Reset
Pad 3 times.
If it seems there is a problem with the oven, contact an authorized Service Center.
IP3248_39V20KP_Eng_07_101022.indd 12IP3248_39V20KP_Eng_07_101022.indd 12 2010-10-22 13:51:172010-10-22 13:51:17