Filter
Top Products
Monitoring the DSU
4-2
7510-A2-GB20-00
March 1997
Viewing System and Test Status
To view System and Test Status information, follow this menu selection
sequence:
Main Menu
→
Status
→
System and Test Status
The System and Test Status screen has three sections:
H Health and Status – Displays messages in priority order (highest to lowest).
Refer to Health and Status Messages, Table 4-2.
H Self-Test Results – Results of the Diagnostic test run on the device itself.
Refer to Self-Test Results Messages, Table 4-3.
H Test Status – Currently active tests. Refer to Test Status Messages,
Table 4-4.
main/status/system
Device Name: Node A Model: 7510
SYSTEM AND TEST STATUS
HEALTH AND STATUS SELF-TEST RESULTS TEST STATUS
Cross Pair Detection Device Fail No Test Active
No Signal
hhh:mm:ss
Memory Fail CSU Loopback Active
Out of Service
hhh:mm:ss
Passed Network-init. CSU LB Active
Out of Frame
hhh:mm:ss
DSU Loopback Active
Excessive BPVs
hhh:mm:ss
Network-init. DSU LB Active
User Data Port DTR Off V.54-initiated DSU LB Active
Device Fail
yyyyyyyy
Local Loopback Active
DSU Operational Sending 511 on Port
Monitoring 511 on Port
Sending 511 on Network
Monitoring 511 on Network
Lamp Test Active
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
ESC for previous menu M
ainMenu Exit
R
efresh Clear