Filter
Top Products
Messages and Troubleshooting
6-2
7510-A2-GB20-00
March 1997
Table 6-1. Device Messages (2 of 2)
Device Message What To DoWhat Message Indicates
Invalid Test
Combination
A loopback or 511 pattern
test was in progress when
Start was selected to start
another test, or was active
on the same or another
interface when Start was
selected.
H Wait until other test ends and
message clears.
H Abort all tests from the Test
menu screen.
H Stop the test from the same
screen the test was started
from.
Please Wait Command takes longer
than 5 seconds.
Wait until message clears.
Test Active A test is running and no
higher priority health and
status messages exist.
H Contact service provider if test
initiated by the network.
H Wait until the other test ends
and message clears.
H Cancel all tests from the Test
screen.
H Stop the test from the same
screen the test was started
from.