Filter
Top Products
Solstice I12+ Cooking Computer for ROV Fryers
Pitco P/N 60149517 & 60149518
Page 15 of 44 L22-378 Rev 3
4 Fresh Oil Supply Monitoring
This computer monitors the Jug-in-Box (JIB) fresh oil supply for oil remaining estimation and oil
supply problems. The computer will monitor utilization of the JIB from on-demand, manual top-offs,
automatic top-offs, and top-off events from other fryers in the battery.
4.1 JIB Oil Remaining:
Low JIB message will show and toggle with the current fryer state when the
available fresh oil has dropped below the Low JIB configuration value (section 10.11.3).
Replace JIB message will show and toggle with the current fryer state when
the available fresh oil has depleted. The operator at this time should replace the JIB with a
new, full supply.
It is not recommended to replace JIB with a less-than-full supply.
To reset the JIB Oil Remaining monitor once the supply has been replaced:
Push-and-hold until is displayed.
Press product key [6] (YES) to reset the fresh oil supply to the Max JIB configuration value
(section 10.11.2).
Note: Only one cooking computer in a fryer battery needs to have the oil remaining monitor enabled
(section 10.11.1).
4.2 JIB Check/Error:
For fryer configurations with the auto top-off option, the JIB error monitor displays the error
message when an auto top-off event has occurred three
times within 15 minutes for a single frypot. This message indicates to the operator that a JIB or
its hose has been installed improperly, the JIB has been emptied and not replaced, or there is
some other fault condition.
Check the JIB and resolve any fault conditions. Press any cook key to clear the Check JIB
message.
When the Check JIB message is displayed, auto top-off for that frypot is temporarily
disabled until the message is cleared and acknowledged.