Filter
Top Products
6
Introduction
This manual is provided by Powermatic covering the safe operation and maintenance procedures for a
Model DT65 Single End Dovetailer. This manual contains instructions on installation, safety precautions,
general operating procedures, maintenance instructions and parts breakdown. This machine has been
designed and constructed to provide years of trouble free operation if used in accordance to instructions
set forth in this manual. If there are any questions or comments, please contact either your local supplier
or Powermatic. Powermatic can also be reached at our web site: www.powermatic.com.
Description
The Model DT65 Dovetailer will make cleanly cut half-blind dovetails for drawer or box construction. A
four-sided template allows any of four pitches, from 1” up to 2-1/2”. The use of different dovetail pitches
will give a unique custom appearance to your work. The cutter is carbide-tipped. The machine has a
magnetic starter, and is built to last with cast iron and steel construction. The pneumatic clamping system
is quick and easy to use.
Specifications
Model Number ...................................................................................................................................DT65
Stock Number...............................................................................................................................1791305
Minimum work piece size (in.) .................................................................................................7-7/8 x 2-3/8
Maximum work piece size (in.) .................................................................................................. 59 x 16-1/2
Minimum dovetail height (in.) .............................................................................................................. 3/16
Maximum dovetail height (in.) ............................................................................................................... 3/4
Minimum front thickness (in.) .............................................................................................................. 9/32
Maximum front thickness (in.) ............................................................................................................ 2-3/8
Minimum side thickness (in.) ................................................................................................................. 3/8
Maximum side thickness (in.) ........................................................................................................... 1-3/16
Number of spindles .................................................................................................................................. 1
Spindle speed (RPM)...................................................................................................................... 18,500
Center-to-center dovetail spacing (in.) ........................................................................ 1, 1-1/2, 2 and 2-1/2
Table height from floor (in.) .................................................................................................................... 45
Overall dimensions (L x W x H) (in.) ........................................................................................ 37 x 44 x 63
Motor ........................................................................................................... TEFC, 1HP, 1Ph, 230V, 60Hz
Dust collection ports diameter (in.) .................................................................................. front 2-1/2, rear 4
Dust collection minimum CFM required ................................................................................................ 500
Approximate Weight, Shipping/Net (lbs.) ....................................................................................... 510/420
The above specifications were current at the time this manual was published, but because of our policy of
continuous improvement, Powermatic reserves the right to change specifications at any time and without
prior notice, without incurring obligations.