Filter
Top Products
9
Installation & Assembly
Tools required for assembly
forklift or hoist with straps/slings
14mm wrench (provided)
[NOTE: A socket set with ratchet wrench may
speed assembly]
4mm hex wrench (provided)
knife or wire cutter
flat head screwdriver
1. Remove the four screws and flat washers
holding the machine to the pallet with a
14mm wrench, as shown in Figure 1.
2. Place lifting straps through the two eyebolts
at the top of the machine (Figure 2). Using
a forklift or hoist, lift the machine off the
pallet and into its desired location. The
Dovetailer should be located in a dry area
with sufficient lighting. Leave plenty of
space around the machine for operations
and routine maintenance work.
3. If desired, the Dovetailer can be further
stabilized by securing it to the floor, using
lag screws through the four holes at the
bottom of the cabinet.
4. A group of cords holds the headstock
secure to the machine frame to prevent it
from moving during shipping. These cords
should now be cut and removed (see
Figure 3).
5. Exposed metal areas of the Dovetailer
(such as the table, template bar, cylinder
clamps, rods, etc.) have been factory
coated with a protectant. This should be
removed with a soft cloth dampened with
kerosene or mineral spirits. Do not use an
abrasive pad. Do not let solvent contact
plastic or rubber parts as it may damage
them.
Attaching Dust Hose
1. Slide the upper end of the hose over the
chute on the dust hood (Figure 4).
2. Tighten the hose clamp with the attached
screw, using a flat head screwdriver.
Figure 1
Figure 2
Figure 3
Figure 4