Filter
Top Products
CHAPTER 3
AMI
®
BIOS USERS GUIDE
3-6
Description of the item on screen follows:
Quick Boot
Set this option to Enabled to permit AMI
®
BIOS to boot within 5
seconds. This option replaces the old ABOVE 1 MB Memory Test option.
1st Boot Device/2nd Boot Device/3rd Boot Device
This option sets the sequence of boot drives.
The settings are:
IDE0 The system will boot from the first HDD.
IDE1 The system will boot from the Second HDD.
IDE2 The system will boot from the Third HDD.
IDE3 The system will boot from the Fourth HDD.
Floppy The system will boot from Floppy.
SCSI The system will boot from the SCSI.
Network The system will boot from the Network drive.
CD-ROM The system will boot from the CD-ROM.
ZIP A:/LS120 The system will boot from ZIP/LS120.
ATAPI ZIP C: The system will boot from ZIP.
Disable Disable this sequence.
Try other Boot Devices
This option sets the device boot, if all the Four Boot Devices failed.
Boot up Num Lock
When this option is set to Off, AMI
®
BIOS turns off the Num Lock
key when the system is powered on. The end user can then use the arrow
keys on both the numeric keypad and the keyboard. The settings are On or
Off. The setup default and BIOS settings are On.
Floppy Drive Swap
Set this option to Enabled to specify that floppy drives A: and B:
are swapped. The setting are Enabled and Disabled. The setup and BIOS
default settings are Disabled.