24
INSTALLATION
Check the ap pli ance is electrically safe and gas sound when you have fi nished.
Unfold the rear edge of pack base tray. Open the grill
door and the Tall oven door. Grip under the facia panel
and lift the front of the cooker.
Carefully push the cooker backwards off the pack base.
Remove the pack base tray. Position the cooker close to
its fi nal position leaving just enough space to get behind
it.
Do not use the door handles or control knobs to
manoeuvre the cooker. Use the hotplate and griddle
bowl areas.
Conversion to LP
If the appliance is to be converted to LP gas do the
conversion at this point. See the conversion section
of these instructions.
Levelling
You are recommended to use a spirit level on a shelf in
one of the ovens to check for level.
Place the cooker in its intended position taking care not
to twist it within the gap between the kitchen units as
damage may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level
the cooker. To adjust the height of the rear of the cooker
use the levelling tool supplied to turn the adjusting nuts
at the front bottom corners of the cooker. To set the front
feet turn the bases to raise or lower.
Fitting a stability bracket
A stability bracket or chain (not supplied by with the
cooker) should be fi tted when the cooker is connected
to a fl exible gas supply.
When fi tting a stability bracket read these instructions
together with the leafl et supplied with the bracket.
1. Place the cooker in its intended position and level
the cooker.
2. Draw a pencil line 70mm from the front edge of the
levelling feet.
3. Mark the centre line for the bracket by measuring
550mm from the left hand side of the cooker.
4. Move the cooker forward.
5. Measure back from the pencil line 500mm to locate
the front edge of the bracket. Position the bracket
so that it is away from centreline of the cooker to
reduce the possibility that it will trap the electrical
connection cable or gas hose. Fix the bracket to the
fl oor.
6. Measure the height from fl oor level to engagement
edge in back of cooker. Add 3mm to this dimension
and assemble the stability bracket to this height. (i.e.
from fl oor level to underside of the top member) and
ensure the bracket does not foul the oven burner
assembly.