Filter
Top Products
RECIRCULATION
If you are using the hood for recirculation,
ensure the charcoal filters are in position
following the instructions contained in the
section “To Remove/Replace the Charcoal
Filters”.
Note: When the hood is used in the
recirculation mode ensure that the plate
(T) has been fixed into the lower chimney
section. If not, fit the plate as illustrated
opposite using two of the self tapping
screws provided in the fixing kit.
FITTING THE CHIMNEY
STACK
The chimney stack consists of two
sections.
1. Fit the upper section (S) first. Expand
the chimney slightly to allow it to be
fitted over the brackets (1) and (2),
and then secure the chimney stack to
bracket (2) using two self tapping
screws provided in the fitting kit.
2. Fit the lower chimney section (I) by
expanding the chimney slightly to
allow it to be fitted over the brackets
(1), and the upper chimney section
and bracket (3).
3. Ensure the bottom edge of the
chimney stack is fitted correctly into
the recess around the top of the
canopy, and secured using the two
self tapping screws as illustrated in the
close-up above.
Note:The upper (S) and lower (I)
chimney stack sections are fixed to the
middle wall bracket (3) by the natural
force of the metal, and the over
lapping of the sections by vigorously
pushing against the centre of the
chimney.
INSTALLING THE CHIMNEY HOOD
13