Filter
Top Products
10
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
Electrical Connections
This appliance must be installed by a qualified electrician
to comply with the relevant Institute of Electrical
Engineers (I.E.E.) regulations and also the local electricity
supply company requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED
Note: All external wiring must comply with the IEE
Regulations for the Electrical Equipment of Buildings.
Connection to the electrical supply can be made with either
a plug and socket, or be permanently wired via a double pole
switch. The hob is supplied with a 3-core cable, 900mm long.
If a replacement cable is fitted it must be 250V high
temperature PVC (85°C), 1 mm²
minimum conductor size.
Plug Connection
For a plug connection a three-pin plug to BS 1363 with a
capacity of not less than 13A must be used and fitted with a
3A fuse, ‘ASTA’ approved to BS 1362.
After replacing the fuse the cover must be refitted. If the
cover is lost, the plug must not be used until a replacement
cover has been obtained from your supplier. The colour of the
correct fuse carrier is that of the coloured insert in the base of
the fuse recess, or stated elsewhere on the plug. Always state
this colour when ordering a replacement fuse carrier.
IMPORTANT: The wires in the mains lead are coloured in
accordance with the following code:
Green and yellow: Earth
Blue: Neutral
Bro
wn: Live
Hotplate checks
Check each burner in turn. There is a spark ignition system
that works when the knob is pressed in. Each burner also has
a special safety device that stops the flow of gas if the flame
goes out.
Push in and turn a control knob to the large flame symbol [
].
Keep holding the knob pressed in to let the gas through to
the burner for few seconds. The igniter should spark and light
the gas.
If, when you let go of the control knob, the burner goes out,
the safety device has not held in. Turn the control to the
OFF position and wait one minute, then try again this time
holding in the control knob for slightly longer.
Customer Care
Please complete your contact details in the front of this
section. Please inform the user how to operate the hotplate
and hand over the instruction pack.
Thank you.