Filter
Top Products
14
ArtNo.320-0002b
- Oven door side screws (Toledo)
Fig.5-2
Once you have removed as much as possible with the scraper,
follow the ‘Daily Care’ procedure outlined above.
To Remove Metal Rub-off
Sliding pans on the hob – especially aluminium or copper
pans – can leave marks on the surface. These marks often
appear like scratches, but can easily be removed using the
procedure described previously for ‘Cleaning spills’. If the
rub-off marks are especially stubborn, use a cleaning cream
together with the razor scraper, as described in ‘Cleaning
burned-on spills’.
Grill
The grill pan and grid should be washed in hot soapy water.
After grilling meats or any foods that soil, leave to soak for a
few minutes immediately after use. Stubborn particles may
be removed from the grid using a nylon brush. Alternatively,
the grill pan can be washed in a dishwasher.
Before you remove any of the grill parts for cleaning,
ensure that they are cool, or use oven gloves.
DO NOT use any abrasive substances.
Control Panel and Doors
Avoid using any abrasive cleaners, including cream cleaners,
on brushed stainless steel surfaces. For best results, use a
liquid detergent or our Multi-purpose Cleaner.
The same cleaner can also be used on the doors. Alternatively,
use a soft cloth wrung out in clean hot soapy water. You can
use the same method for cleaning the control panel and
knobs (although we do supply a specialist Fascia Cleaner).
After cleaning, polish with a dry cloth.
Ovens
The oven door front panels can be taken off so that the glass
panels can be cleaned. Move the cooker forward to gain
access to the sides (see the ‘Moving the Cooker’ section under
‘Installation’).
Door Panel
Open the oven door slightly and remove the front panel
fixing screws from the door sides, two each side (Fig.5-2).
Carefully lift off the outer door panel. The inside face of the
glass panels can now be cleaned – take care not to disturb or
wet the door insulation.
The door is triple glazed but the inner two panels are fixed
and should not be separated. After cleaning, carefully refit the
outer door panel and replace the side fixing screws.