Filter
Top Products
Version 4 27 Feb 08
Installing the MDC-2100/MDC-900
In order to use the MDC with the OSCOR, a special connector (the OEP-2100) must be
installed in the connector tray of the OSCOR. This connector should be installed
permanently into the connector tray and provides for easy connection of the MDC while
not affecting the OSCOR normal operation. Note the step numbers on Figure 4 below to
assist in the installation.
To install the OEP-2100:
1. Turn the OSCOR off and wait at least 30 seconds before proceeding.
2. Remove the OEP from the packaging and insert the mini-din connector (OSCOR
EXP.) into the EXPANSION PORT of the OSCOR as shown in Figure 4. (You may
have to unplug the two tape recorder cables labeled REMOTE OUT RECORDER).
3. Insert the metal support bar into the connector tray. Align the depression at the center
of the bar with the screw head at the top of the OEP. (The cables that provide
connection to the tape recorder controls must be placed under the metal support.)
4. Use the hex wrench to tighten the two hex screws. (This holds the OEP in place.)
5. Unplug the HF/UHF BNC connector from the OSCOR and plug it into the OEP at the
ANTENNA PANEL RF jack.
6. Connect the OEP BNC cable (HF/UHF INPUT) to the OSCOR HF/UHF INPUT.
To install the MDC-2100 or MDC-900:
1. Plug the MDC BNC connector into OEP BNC jack (MDC RF).
2. Plug MDC mini-din connector into the MDC POWER/CTRL jack.
3. Utilize the OSCOR keypad to control the MDC.
3
4
3
5
6
2
Figure 4: INSTALLATION OF THE OEP
The MDC can be used in a stationary position sitting on the provided tripod or it can be
moved around the environment to provide a thorough sweep of the area. For best
operation, the MDC should be located at least three feet away from the OSCOR. Position
the metal housing towards the OSCOR.
REI MDC-2100/MDC-900 5