Filter
Top Products
Caring For Your Range
Bum And Electrical Shock Hazard
Make sure all controls are OFF and
the range is cool before cleaning.
Failure to do so can result in burns
or electrical shock.
The control knobs
1. Turn control knobs to the OFF
position.
2. PulI control knobs straight off.
3. Wash in warm, soapy water.
4. Rinse well and dry completely. Do
not soak.
The control panel
1. Wipe with warm, soapy water or
spray glass cleaner, and a soft
cloth.
2. Rinse well.
3. Dry with soft cloth.
4. Replace control knobs by pushing
them firmly into place.
NOTE: When cleaning, never use steel
wool, abrasives, or commercial oven
cleaners which may damage finish. After
cleaning, make sure all control knobs
point to the OFF position.
The surface units and
reflector bowls
Removing
1. Turn off alI surface units and let
cool.
2. Lift the edge of the unit opposite
the receptacle, just enough to clear
the reflector bowl.
3. Pull the surface unit straight away
from the receptacle.
4. Lift out the reflector bowl. See
Cleaning Chart on page 12 for
cleaning instructions.
Replacing
1, Make sure alI surface units are
turned OFF.
2. Line up openings in the reflector
bowl with the surface unit
receptacle.
3. Hold the surface unit as level as
possible with the terminal just
started into the receptacle. Push
the surface unit terminal into the
receptacle.
4. When the terminal is pushed into
the receptacle as far as it will go,
the surface unit wilI fit into the
reflector bowl.
Reflector bowls reflect heat back to the
utensils on the surface units. They also
help catch spills. When they are kept
clean, they reflect heat better and look
new longer.
If a reflector bowl gets discolored, some
of the utensils may not be flat enough,
or some may be too large for the surface
unit. In either case, some of the heat
that’s meant to go into or around a
utensil goes down and heats the
reflector bowl. This extra heat can
discolor it.
Fire And Electrical Shock Hazard
1 ;;;;,“,he reflectqr bowls 1
with foil. Fire or electrical shock
Page 9