Filter
Top Products
Using Your Range
Oven indicator Left front Electronic clocWTv¶inute Surface burner Clean indicator
Setting the electronic clock
The electronic clock is a digital clock
with a Minute Timer and automatic
control cooking cycle. Time-of-day,
Minute Timer times and cook times are
set by pushing command buttons on
either side of the display.
Oven I
ieft rear control
temperature control
knob
Using the surface burners
Push Fn
andtum
Control knobs must be pushed in, then
turned to the LlTE position. The
clicking sound is the ignition sparlang.
To stop the clicking sound after the
burner lights, turn the control lmob
back to a desired setting. The control
knob can be set anywhere between HI
and OFF.
Surface burner markers
The solid dot in the surface burner
marker shows which surface burner is
turned on by that knob.
Until you get used to the settings, use
the following as a guide. For best
results, start cooking at the high
settings, then turn the control knob
down to continue cooking.
Use LITE to light the burner. After the
burner lights. turn control back to a
desired setting to stop the clicking of
the ignition.
Use a high setting to start food
cooking; to bring liquids to a boil.
Use a medium setting to continue
cooking or to fry chicken or pancakes;
for gravy, puddings and icing; to cook
large amounts of vegetables.
Use a low setting to keep food warm
until ready to serve.
NOTE: DO not cook with the control in
the LlTE position.
Hold a lit match near a burner and-
slowly turn the control knob on until the
burner lights. After the burner lights,
turn the control knob to the desired
setting.
Bum, Fire And Explosion Hazard
. Burner flame should not extend
beyond the edge of the cooking
utensil. The flame can bum you
and cause poor cooking retits.
. Be sure all control knobs are
turned to OFF when you are not
cooking. Someone could be
burned or a fire could start if a
burner is accidentally left ON.
. If the flame should go out while
cooking, or if there is a strong gas
odor, turn the burners OFF. Wait
five minutes for the gas odor to
disappear, before relighting
burner. If gas odor is still present,
see safety note on page 2. Failure
to follow these precautions could
result in explosion or fire.
-Do not attempt to light the oven
burner during a power failure.
Personal injury could result.
1. When the range is connected to
power, or a power failure longer
than three seconds occurs, “i2:OO”
will flash on the display.
2. Push the Cancel/Clock button.
3. Set the desired time by pushing
the Up and Down buttons. The
time will increase or decrease on
the display, depending upon which
button you push. “PM” will appear
on the display for a PM time
setting.
Setting the electronic Minute
Timer
The Minute Timer does not start or stop
the oven. It works like a kitchen timer. It
can be set in hours and minutes up to 9
hours 59 minutes. When the set time is
up. you will hear a l/2-second on and
l/2-second off tone and the lower dot in
the middle of the display will flash. Press
the Minute Timer button to cancel the
tone and flashing dot.
l.IPush the Minute Timer button.
2. Set the desired time by pushing
the Up and Down buttons. The
time will increase or decrease on
the display, depending upon which
button you push. The lower dot in
the middle of the display will light
up, indicating that the Minute
Timer is on.
3. The display will show the set time,
then return to time-of-day.
4. To see the remaining set time
before the set time is up, press the
Minute Timer button.
To cancel the Minute Timer:
Push the Minute Timer button, followed
by the Up or Down buttons until “0:OO”
shows on the display.
Page 4