Filter
Top Products
The storage drawer
The storage drawer IS for storing pots
and pans. The drawer can be removed to
make it easier to clean under the range,
and to check for installation of the anti-
tip bracket(s). Use care when handling
the drawer.
Removing the storage drawer:
I---w
Lever
1. Empty drawer of any pots and
pans before removing drawer. Pull
drawer straight out to the stop.
2. Push up black plastic lever on both
sides of drawer.
Replacing the storage drawer:
Ball bearings
I. Make sure ball bearings on oven
slide rail are positioned toward
the front of the opening.
2. Fit ends of drawer slide rails into
the oven slide rails on both sides
of opening.
3. Slide drawer closed.
To verify that the anti-tip
bracket(s) is engaged:
m Remove storage drawer.
1 Look to see if the anti-tip bracket(s)
is attached to floor with screws.
m Make sure rear leveling leg(s) is
positioned under bracket(s).
n See “Important Safety Instructions”
on page 2 and Installation
Instructions for further detai!s.
NOTE: The range will not tip during
normal use. Tipping can occur if
excessive force or weight is applied to
open door without anti-tip bracket(s)
properly secured.
3. Pull drawer out a little farther untrl
levers stay in “up” position. Pull
drawer the rest of the way out.
Page 7