Filter
Top Products
3.3 Adjustment of feet
.
3.4 Gas connection
the hose must never be at any point in its length in contact with the 'hot' parts of
the cooker;
the hose must never be longer than 1.5 metre;
the hose must not be subject to any tension or torsional stress and it must not
have any excessively narrow curves or bottlenecks;
the hose must be easy to inspect along its entire length to check its condition;
the hose must always be in good condition, never attempt to repair.
! The installation must comply with gas safety (installation and use) regulations
1984. In all cases for the above, by law, a qualified, corgi approved engineer must
be called for installation.
Your stands on 4 adjustable feet. When
the product is placed where it is to be used, check
if the product is balanced. If it is not balanced, you
can make the adjustment by turning the feet
clockwise if required. It is possible to raise the
appliance maximum 35mm by the feet. If the feet
are adjusted do not move the appliance by
dragging, it should be moved by lifting it up
Assembly of gas supply and leakage check
The cooker should be connected to the gas-supply by a gas safe registered
installer. During installation of this product it is essential to fit an approved gas tap
to isolate the supply from the appliance for the convenience of any subsequent
removal or servicing. Connection of the appliance to the gas mains or liquid gas
must be carried out according to the prescribed regulation in force, and only after it
is ascertained that it is adaptable to the type of gas to be used. You can find the
information related to appropriate gas types and appropriate gas injectors on
technical data table. If the pressure of used gas is different than these values
stated or not stable in your area, it may be required to assemble an available
pressure regulator on the gas inlet. It is certainly required to contact to the
authorised service to make these adjusments.
The points that must be checked during flexible hose assembly
Connecting the gas supply
To make the connection, a flexible hose should be used corresponding to the
current gas regulations which are:
As gas is turned on, all connection parts and hose must be checked with soapy
water or leakage fluids. Do not use naked flame to check gas leakage. All metal
components used during gas connection must be clear of rust. Also check the
expiry dates of components to be used.
product
Figure 6
For Customer Services, Spare parts & Warranty Information please call 0845 683 8717
7