Filter
Top Products
Flame safety device:
.
Oven / Grill Burners
.
4.1.1 Control of the hob burners
Hob Burners
This hob is equipped with flame failure device provide security in case of
accidentally extinguished flame. If such a case occurs, the device will block the
burners gas lines and will avoid any accumulation
of unburned gas. Wait 90 seconds before re-igniting an extinguished gas burner
Regardless of the model of your appliance, all oven burners are equipped with a
gas safety device. For this reason, during ignition, keep the oven knob pressed
until you see stable flames. If the flames are cut out after you release the knob,
repeat the procedure again. If the oven burner does not ignite after you keep the
burner knob pressed for 30 seconds, open the oven door and do not attempt re-
ignition for at least 90 seconds. When oven flames go out accidentally, repeat the
same procedure
The knob has 3 positions: Off (0), maximum (big flame symbol) and minimum
(small flame symbol). After you ignite the burner in maximum position; you can
adjust the flame length between maximum and min. positions. Do not operate the
burners when the knob position is between maximum and off positions.
After the ignition, check the flames visually. If you
see yellow tip, lifted or unstable flames; turn the
gas flow off, and check the assembly of burner
caps and crowns (Figure 20). Also, make sure that
no liquid has flown into the burner cups. If the
burner flame goes out accidentally, turn the burner
off, ventilate the kitchen with fresh air, and do not
attempt re-ignition for 90 sec.
When turning the hob off, turn the knob in the
clockwise direction so that the knob shows "0"
position or the marker on the knob points upwards.
Figure 18
Cap
Crown
Spark
Plug
Burner
Cup
MAX. position
OFF position
Figure 17
Modulated
MIN. position
For Customer Services, Spare parts & Warranty Information please call 0845 683 8717
13