Filter
Top Products
46
ENGLISH
Machine actions Causes Solutions
The machine grinds the
co ee beans but no co ee
comes out.
(See note)
There is no water. Fill the water tank and prime the
circuit (chapter “Using the machine
for the rst time”).
The brew group is dirty. Clean the brew group ("Weekly clea-
ning fo the brew group" chapter).
The circuit is not primed. Prime the circuit (chapter “Using the
machine for the rst time”).
This might occur when the ma-
chine is automatically adjusting
the dose.
Brew a few cups of co ee as de-
scribed in chapter "Saeco Adapting
System".
The dispensing spout is dirty. Clean the dispensing spout.
Co ee is too weak.
(See note)
This might occur when the ma-
chine is automatically adjusting
the dose.
Brew a few cups of co ee as de-
scribed in chapter "Saeco Adapting
System".
Co ee is brewed slowly.
(See note)
The co ee grind is too ne. Change co ee blend or adjust the
grind as explained in chapter “Adju-
sting the ceramic co ee grinder”.
The circuit is not primed. Prime the circuit (chapter “Using the
machine for the rst time”).
The brew group is dirty. Clean the brew group ("Weekly clea-
ning fo the brew group" chapter).
Co ee leaks out of the
dispensing spout.
The dispensing spout is clogged. Clean the dispensing spout and its
holes.
Note:
These problems can be considered normal if the co ee blend has been
changed or if the machine has just been installed. In this case wait until
the machine performs a self-adjusting operation as described in chapter
“Saeco Adapting System”.