Filter
Top Products
34
INSTALLATION OF THE WATER DISPENSER LINE
Connect the water line to the refrigerator
Compression Nut
Compression fitting
Sleeve
Compression Nut
Ferrule
Ferrule
- Slip the compression nut and plastic ferrule through the plastic tube.
- After inserting the sleeve, tighten the compression nut onto 1/4”
compression fitting(union).
Do not overtighten the compression nut.
NOTE
Waterline must be connected to drinkable water only
NOTE
- Slip the compression ferrule and nut on copper
(or plastic) tubing as shown.
Tighten the comperssion nut onto the compres-
sion fitting(union).
- Turn water on and check for any leakege.
WARRANTY INFORMATION
This water line installation is not covered by the refriger-ator
or ice maker manufacturer's warranty.
Follow these instructions carefully to minimise the risk of
expensive water damage.
Note:
If the coupler does not fit on the current tap, go
the nearest authorised service dealer and purchase
the right couplers fittings.
Check the water supply line
Connect the water line to the refrigerator.
Connect the water pipe with coupler and tap.
- Close the main water tap.
- Connect coupler “A” to the tap.
- Every join should be protected with sealing tape.
(Case 2)
COUPLER “A”
TAP
CAUTION
The water line must be connect-ed
to the cold water pipe.
If it is connected to the hot water
pipe, it may cause the
purifier to malfunction.
- Remove the compressor cover of the refrigerator.
- Connect the water line to the valve, as shown in the figure.
- When connected, check if there is any leakage.
If any, repeat the connection.
- Reattach the compressor cover of the refrigerator.
WATER LINE
CONNECTION NUT
COMPRESSOR COVER OF
REFRIGERATOR