Filter
Top Products
Setting Up _13
01 SETTING UP
3
3
7
4
5. Position the top table (
2
) in place. Insert and tighten
the 3 screws into the top table with a philips screw
driver(+). After door opened, reinsert the cap top table
(
1
) and close the doors.
When reattaching the top table, make sure that the
wires are not pressed or damaged by the hinge cover.
After assembling, close the door and check to see
whether the door has gaps between gaskets or is tilted.
If you see one of them, please refer to “Adjusting the
doors” page on 15.
1
2
REATTACHING THE REFRIGERATOR DOORS
• The Water Line must be fully inserted to the
center of transparent coupler (Type A) or the
line (Type B) to prevent water leakage from the
dispenser.
• Insert the clip in the install pack and check that
it holds the line fi rmly.
CAUTION
5
4. Connect the water line (
5
) and then insert a clip
on the coupler with pulling tube. Connect the one
connector (
4
) on left side door, the other connector
(
7
) on right side door and two connectors (
3
) at
each side of the top cap.
The clip is enveloped inside of the top cap.
Center of Transparent coupler
Center of Transparent coupler
The Guide Lines
The Guide Lines
Dispenser
Dispenser
clip A (1/4”)
clip A (1/4”)
(6.35mm)
(6.35mm)
clip A (1/4”)
clip A (1/4”)
(6.35mm)
(6.35mm)
Type A
Type A
Type B
Type B
DA68-01827B-17.indb 13DA68-01827B-17.indb 13 2014. 5. 8. 4:392014. 5. 8. 4:39