Samsung RFG237AABP Refrigerator User Manual


 
Operating _41
02 OPERATING
Ordering a Replacement Water Filter
For a replacement water fi lter, you can visit your local home improvement center or contact the Samsung Parts
distributor.
Be sure the replacement water fi lter has the SAMSUNG logo on the box and on the water fi lter.
Link: http://www.samsungparts.com
5. Lastly, Flush 3 gallons through fi lter before use (fl ush approximately 6 minutes) Make sure that
water fl ows clearly again before drinking.
Be sure to fl ush the dispenser thoroughly otherwise water may drip from the dispenser.
This means that there is still air in the line.
Do NOT use the water or ice dispenser without a water fi lter cartridge because the water line may become
blocked.
4. After above steps, press and hold the Alarm / Reset Filter (3 sec) button for 3 seconds to reset
the fi lter.
CHANGING THE WATER FILTER
To reduce risk of water damage to your property DO NOT use generic brands of water fi lters in your
SAMSUNG Refrigerator. USE ONLY SAMSUNG BRAND WATER FILTERS.
SAMSUNG will not be legally responsible for any damage, including, but not limited to property damage
caused by water leakage from use of a generic water fi lter. SAMSUNG Refrigerators are designed to work
ONLY WITH SAMSUNG WATER Filter.
The “Filter” light lets you know when it is time to change your water fi lter cartridge. To
give you preparation time to get a new fi lter, the red light will come on just before the
capacity of the current fi lter runs out. Changing the fi lter on time provides you with the
freshest, cleanest water from your refrigerator.
1. Take a new water fi lter and put a month indicator sticker (
1
) on the fi lter as shown.
The date on the sticker must be six months from the current date. For example, if you are replacing
the water fi lter in March, put the “SEP” (September) sticker on the fi lter to remind you to replace in
September. Normal fi lter life is about 6 months.
2. Remove the new fi lter’s protective cap (
2
) and remove the old fi lter.
3. Position and insert the new fi lter into the cover fi lter.
Slowly turn the water fi lter clockwise to align with the printing mark on the cover, locking the fi lter in
position. Make sure to align the water fi lter label (
3
) mark with the center of cover fi lter printing as
illustrated. Remember, do not over-tighten.
Turn until the
label aligned.
Cover fi lter
Indicator sticker
Indicator sticker
(month indicator)
(month indicator)
1
2
3
WARNING
DA68-01827B-17.indb 41DA68-01827B-17.indb 41 2014. 5. 8.  4:392014. 5. 8.  4:39