Filter
Top Products
setting up
_11
01 SETTING UP
Removing residual matter inside the water
supply line after installing filter.
1. Turn ON the main water supply.
2. Press the Water button and push the Dispenser
Lever.
3. Flush 1 gallons of water through the filter before
use. (Flush approximately 6 minutes.) This will
clean the water supply system and remove air
from the lines.
4. Additional flushing may be required in some
households.
5. Open the refrigerator door and make sure there
are no water leaks coming from the water filter.
A newly installed water filter cartridge may
cause water to briefly spurt from the water
dispenser. This is due to air getting into the
line. It should pose no problem to operation.
Check the amount of water supplied to the ice
tray.
1. Lift up the icemaker cover and gently pull it out.
2. When you press the Test button for 3 seconds,
the ice cube container is filled with water from the
water supply tap. Check to make sure the amount
of water is correct (see the illustration below). If the
water level is too low, the ice cubes will be small.
This is a water pressure problem from within the
main water pipes, not the refrigerator.
- It will take a few minutes to reach the amount
of water you want.
- Do not press the test button continuously when
the tray is filled with ice or water. Water may
overflow or ice jamming may occur.
- When the bucket is not installed, the ice maker
does not work.
- When "Ice maker will not work when the ice
bucket is not installed" message appears on the
display panel, reinsert the bucket and/or make
sure it’s installed properly.
Ice maker
1
Test button
Check the water
level
2
CAUTION
DA68-02500B.indb 11 2012.6.7 1:40:5 PM