Filter
Top Products
08_ setting up
Reattaching the freezer doors
To reattach the freezer doors, replace parts in reverse
order
Reattaching the Water Supply Line
1. The Water Line must be fully Inserted to the center
of transparent coupler to prevent water leakage
from the dispenser.
2. Insert the 2 clips in the install pack and check that
each clip holds the line firmly.
Do not cut the water line. Gently separate it
from the coupler.
Removing the Fridge Door
1. Remove a screw on the upper hinge cover
1
.
With the door open, disengage the two locking
tabs with a flat-head screw driver
2
and remove
it while the lifting up the rear of the cover
3
, and
then disconnect the wires by gently pulling them
apart
4
.
2. Removing the FIXER HINGE ,and next take off the
upper hinge. Be careful that the door does not fall
on you as you are removing it.
Be sure to keep track of all parts you are
removing.
3. Remove the door from the
lower hinge
5
by lifting the
door straight up
6
.
Reattaching the Fridge door
To reattach the fridge doors, replace parts in
reverse order.
LEVELLING THE REFRIGERATOR
Now that the doors are back on the refrigerator, you
want to make sure the refrigerator is level so that you
can make final adjustments. If the refrigerator is not
level, it will not be possible to get the doors perfectly
even.
When the Freezer part is lower than the Fridge
part.
Insert a flat-blade screwdriver into a slot on the
Freezer Leg, then turn it clockwise.
When the Fridge part is lower than the Freezer
part.
Insert a flat-blade screwdriver into a slot on the Fridge
Leg, then turn it clockwise.
Refer to the next section for the best way to
make very minor adjustments to the doors.
Freezer Leg
Screw Driver
Fridge Leg
Screw Driver
6
5
3
2
4
1
Center of transparent coupler
clip A (¼”)
(6.35mm)
DA68-02500B.indb 8 2012.6.7 1:39:59 PM