Filter
Top Products
9. Check the volume of water supplied to the
ice maker.
1) Remove the upper ice maker from the refrig-
erator.
ICE MAKER
CHECK THE WATER SUPPLIED
TEST BUTTON
TOO MUCH
OPTIMUM
LEVEL
2) When you press the test button, the ice cube container is filled with water from the
water supply tap for the ice maker. Check the amount of water (see the illustration
below). If there is too little water, the ice cubes will be small inacceptably. This is not
a problem with the fridge/freezer but with the water pressure in the pipe and
occurs frequently. When this problem occurs, use the following method to check the
volume of water supplied.
8. Complete the installation of the water dis-
penser line.
1) Switch on the fridge/freezer and press the
lever on the left of the dispenser until water
runs out through the water tube (approximate-
ly two to three minutes).
(Press it until all air has been empty.)
2) At this time, check for any possible leakages
at the joins in the water tube.
After securing the water tube, move the
fridge/freezer to the required location.
Once the fridge/freezer is in position, move it
as little as possible.
TOO LITTLE
14
DA68-00500P 6/26/02 2:35 PM Page 30