Filter
Top Products
9InRow RC Operation and Maintenance Manual
Using the Display
Every time you apply power to the cooling unit, the display interface initializes, causing the LEDs to cycle and
the alarm-tone to activate.
Scrolling status screens
After start-up, the interface displays the firmware revision number of the display interface. The display interface
then scrolls automatically and continuously through screens of status information. Press the up or down arrow
key to interrupt the automatic scrolling and view a specific status screen. To return to the scrolling status
screens, press ESC from one of the main menu screens.
Main menu screens
On any top-level status screen, press the ENTER or ESC key to open the first
main menu screen.
All main menu choices are displayed on a series of six main menu screens.
Navigating the main menu
Selector arrow: Press the up or down arrow key to move the selector arrow
to a main menu option. Press the ENTER key to view the selected sub-menu
screen. In the example shown below, the selector arrow points to the Set Date
and Time setting. To select that item, press the ENTER key.
NOTE: If the selector arrow is on the top line of a main menu screen, press the
up arrow key to move the selector arrow to the top line of the previous screen.
Status Screen Name Status Information Displayed
InRow RC • On/Standby
• Unit identifier
• Cooling Unit name
• Cooling Unit location
Group • Alarms/No Alarms
• Cool Outpt (Cool Output) kW
• Cool Setpt (Cool Setpoint) °C (or °F)
• Max Rack (Maximum Rack Temperature) °C (or °F)
Unit •Alarms/No Alarms
• Cool Output kW
• Max Rack In (Maximum Rack Inlet Temperature) °C (or °F)
• Air Flow l/s (liters per second) or CFM (cubic feet per minute)
On/Standby
View Alarms
Clear Alarms
View Event Log
na5388a
Clear Event Log
Configure Modbus
Set Date & Time
Set Password
Set Display Units
Configure Display
Configure Network
About InRow RC
Set Identification
Service Intervals
View Run Hours
Configure Unit
Configure Group
Set Group PIDs
View Group Status
View Unit Status
Set Group Setpoints
Set Unit Threshlds
NOTE: Once a period of inactivity (at the keys of the display interface)
exceeds the Password Timeout setting, the display interface returns to
the scrolling status screens.
For information on setting the time-out duration, see
“Password & timeout” on page 21.
na5271a
Time: 13:15:23
Date: 18-Nov-2010
Format: dd/mm/yyyy