Schneider Electric ACRC501 Water Dispenser User Manual


 
23InRow RC Operation and Maintenance Manual
Network Configuration
The cooling unit is shipped with a Network Management Card (NMC) that enables you to manage the cooling
unit over your network. Configure the network settings for the Network Management Card from the display
interface. The management card allows remote control and configuration of the cooling unit.
Configure the network
Path: Main > Configure Network
MAC Address: Displays the unique network identifier assigned to the Network Management Card of the
cooling unit installed in the cooling unit at the factory.
IP Address: You will be prompted to enter an Admin password. Enter the password and press ENTER to
return to the IP screen. Press ENTER again to change the following settings for Manual boot mode only.
IP: Enter the IP address assigned to the Network Management Card of the cooling unit.
SM: Enter the subnet mask for the Network Management Card of the cooling unit.
GW: Enter the default gateway for the Network Management Card of the cooling unit.
Boot Mode: Set the method by which the Network Management Card of the cooling unit will acquire its network
settings.
Manual: Enter the IP Address, subnet mask, and default gateway using the IP Address menu.
BOOTP: Set the Network Management Card of the cooling unit to obtain its network settings from a
BOOTP server.
DHCP: Set the Network Management Card of the cooling unit to obtain its network settings from a DHCP
server.
By default, DHCP requires an Schneider Electric cookie before it will accept an IP address.
See “DHCP:” on page 32 for more information.
BOOTPDHCP: Set the Network Management Card of the cooling unit to search for its network settings
from either a BOOTP or a DHCP server.