Schneider Electric ACRC501 Water Dispenser User Manual


 
InRow RC Operation and Maintenance Manual34
Windows command format:
ping 156.205.14.141 -l 113
LINUX command format:
ping 156.205.14.141 -s 113
3. Use Telnet to access the Network Management Card at its newly assigned IP address. For example:
telnet 156.205.14.141
4. Use apc for both user name and password.
See “Control console” on page 34 to finish the configuration.
Control console
After you log on at the control console, as described in“Local access to the control console” on page 33 or
“Remote access to the control console” on page 33:
1. Choose Network from the Control Console menu.
2. Choose TCP/IP from the Network menu.
3. If you are not using a BOOTP or DHCP server to configure the TCP/IP settings, select the Boot Mode
menu and then select Manual boot mode.
4. Set the System IP, Subnet Mask, and Default Gateway address values. (Changes will take effect
when you log out.)
5. Press ENTER to return to the TCP/IP menu.
6. Press CTRL+C to exit to the Control Console menu.
7. Log out (option 4 in the Control Console menu).
NOTE: If you disconnected a cable from the local computer during the procedure described in “Local
access to the control console” on page 33, reconnect that cable and restart the associated service.