Filter
Top Products
Servicing The Ice Dispenser
Certain conditions witt require you to
service the ice maker and dispenser.
The unit has been designed so that you
can do such servicing with a minimum
of effort.
Cold dry air has to circulate in the
freezer to maintain a safe freezing tem-
perature. Thus. cubes stored in the bin
will tend to evaporate and flow together
if not used regularly
You should remove the bin and
empty the contents:
= After the first few harvests ofice have
been made by a newly installedunit,
This will allow any impurities in the
line to be flushed out,
If you are going to be gone for longer
than a week_ Raise the ice maker
shut-off arm to stop ice production
and prevent the cubes from freezing
into a mass around the ice auger.
2 To stop ice production or to remove
the ice bin: take hold of wire arm
near black housing, and lift up, There
will be an audible "click" when ice
maker shuts off. The wire arm stays
in the upper' position, (See Fig, 19,)
As long as the arm is in this position,
ice wilt not be made. The unit will
continue to dispense cubes from the
ice bin until oil have been used_
SHUT-OFF ARM
TO STOP THE
ICEt,_AKER FIGURE 19
To remove ice bin assembly: Lift up •
the ice bin assembly _/4",then pull out!
if the ice cubes become frozen to '1"heAutomatic Shut-off stops ice
each other and around the ice auger, making by raising the control arm when
If the ice cubes become frozen the ice bin is removed. (See Fig. 20,)
together on the back ledge of the ice
bin, Periodic cleaning of the ice bin
may alleviate this occurrence_ Clean
with warm water and dry before
replacing bin. Do not use an ice pick
to break apart ice,
ice maker control arm. The wire con-
trol arm on the automatic ice maker has
2 functions:
1_Normal Operation: the wire arm is
in the down position; ice will be
made, See Fig, 18.
EXTENSION
\ FIGURE 18
AU'FOMATIC SNUT-OFF ARM
THE AUTOMATIC SHUT*OFF tS SHOWN
tN THE OFF FOSIT_ON fWHEN
THE =CE STORAG_ SIN HAS
SE_NREMOWO) FIGURE 20
AUTOMATIC SHUT-OFF
10