Filter
Top Products
Connect the Ice and Water'
System to Cold Water
Supply.
Refer to the instructions on the back of
the cabinet.
, CAUTION:
Toavoid cross threading and
water ieaks, you must start alt the
water tube fittings several turns by
hand before tightening with
wrenches. DO NOT OVER-
TIGHTEN. Also be sure to double
check for water leaks after turning
on the water pressure to the
refrigerator.
Pilacement and Leveling
i,i i I,IIH
Placement
On some counter tops there is a 1"
overhang If this is the case, the front
corners of the counter top must be
trimmed off at a 45° angle for the refrig-
erator and freezer doorclearance (see
Figure 15) To build in your refrigerator a
Perimeter Trim Kit is available at an
additional cost.
A recessed electrical outlet installedon
the back kitchen wallatfows for a built-in
installation of your refrigerator.
To build in your refrigerator with other
options, such as wood or laminate con-
sult with a local kitchen designer.
).......... ,,!,..ll!,............I
Units have front wheets that can be
adjusted by turning a screw as shown in
Figure 16.
CAUTION
To Avoid Property Damage to soft
vinyl floodng follow the floor prod-
uct manufacturer's recommenda-
tions when installingor moving
the refrigerator.
If the floor is uneven from side to side,
place thin metal plates under one of the
rear wheels.
FIGURE 15
Leveling
Installthe unit on a solid floor that is
strong enough to support the combined
weight of the unit, approximately 320
tbs.; and the food, maximum of 625 ibs
with an approximate combined weight
of 945 tbs.
]'he unit must be level to insurecorn-
plete door closingsand properice mak-
ing. Improper leveling will cause water
spills and uneven ice cube size.
POWER SWITCH
Located behind the toe grille in the cen-
ter is a switch. This switch must be in
the on position before you proceed any
further.
SWITCH