Filter
Top Products
REMOVABLE KNOBS
All control knobs may be removed for easy cleanlng by
pulllng the knob stralght off the stem. Be sum that the
knob Is In the OFF positlon before removal.
Hint: Slip athin cloth (such as a handkerchief) or a piece
of string under and around the knob edge and pull up.
Caution: Read these instrucUons
carefully before replacing the
knobs. Replacing the knobs improp-
erly will damage the knobs and the
spring clip on the stems. If this
happens, the knobs will fit loosely.
To replace the knob:
1. The knob stem has a groove Ineach side. The groove
on one side has a spring clip. The other groove Is
clear (see Illustration).
2. Check the Inside of the knob and find the molded rib.
3. Replace the knob by fltUng the molded rib Inside the
knob Into the clear groove on the stem.
MOLDED
RIB
. SPRING
_CLIP
CLEAR GROOVE
IN STEM
Note: Be sure to replace knobs on correct
stems from which they came.
REMOVABLE COOKTOP UNITS
The cooktop elements can be unplugged and the bowls
removed for cleaning.
Be sure all cooktop unit control knobs are turned
off and elements are cool before you remove or
replace a cooktop unit.
To remove:
1. Grasp element, tilt It upward slightly to clear the
bowl, then pull away from the receptacle. The element
will not sit level when replaced If It Is forced too far
upward when removed.
2. For medelswlth porcelain enameled refleotor bewls,
remove the chrome trim ring.
3. Lift out the bowl.
Do not put the element Into water. It cleans Itself when
heated during normal use.
To replace:
1. Replace the bowh Be sure the receptacle Isshowing
in the bowl opening.
2. For mndelswlth porcelain enameled refleotor bewls,
replace chrome trim ring.
3. Slidethe plug ofthe element firmly Intothe receptacle
and lower the element into place.
IMPORTANT: Never operate a cooktop element
without the bowl in place. This can cause
scorching of the eooktop, burning of wiring
insulation and loss of energy.
CAUTION: Do not pull element up mere than
(" or damage to the receptacle will
Occur,
16 NEMNT37