Filter
Top Products
Instructions for the User
24
9. EXTRAORDINARY MAINTENANCE
The oven may require extraordinary maintenance or replacement of parts subject to wear such as seals,
bulbs, and so on. The following instructions describe how to carry out these minor maintenance
operations.
WARNING
ELECTRICAL SHOCK HAZARD
Before any intervention, disconnect the power supply of the device.
9.1 Replacement of light bulb
Remove cover A by twisting anticlockwise,
replace bulb B with another same bulb. Refit the cover A.
NOTE: Only use oven bulbs (T 600°F).
9.2 Removing the door
Open the door completely and fit the pins (supplied) into the holes from the inside.
Close the door to an angle of about 45°, lift it and remove it from its seat. To replace, fit the hinges into
the grooves provided, then lower the door until it comes to rest and extract the pins. If the pins are lost,
two screwdrivers can also be used.
9.3 Oven door seal
To permit thorough cleaning of the oven, the seal may be removed. Before removing
the seal, take off the door as described above. Once the door has been taken off, lift
the tabs at the corners as shown in the figure.