Filter
Top Products
Instructions for the installer
EN
36
12.3 Positioning the oven
Never use the oven door to lever the oven into place when fitting. Avoid exerting
too much pressure on the oven door when open.
It is recommended to install the oven with the help of a second person.
The base on which the oven is resting must be complete as shown in the
illustrations below.
Under the large oven door, the counter
must not protrude at least 1 cm. This is
in order to allow complete opening of
the door.
The oven is designed for mounting into any piece of furniture as long as it is
heat-resistant. For positioning, follow the dimensions of the counter indicated in
figure 1-2-3 and the operational dimensions of the oven indicated in figure 4-5.
Depending on the installation possibilities a ventilation opening must be
prepared for the appliance. This opening must be
• or on the lower/front part of the counter (figure 1) for a total surface of at
least 200 cm².
• either on the upper/rear part of the counter (figure 2) of 35-40 mm deep;
To secure the appliance to the counter, screw in 4 screws through the holes in
the frame indicated in figure 6.