Filter
Top Products
Instructions for the installer
11
4 ELECTRICAL CONNECTION
Make sure that the voltage and capacity of the power line conform to the data shown
on the plate located under the casing. Do not remove this plate for any reason.
The plug on the end of the supply cable and the wall socket must be the same type
and conform to the current electrical system regulations. Check that the power line is
adequately grounded.
On the power line, install an omnipolar cut-off device with contact cut-off distance
greater than or equal to 3 mm, located in an easily accessible position near the unit.
Do not use reducers, adapters or shunts.
If the power cable is replaced, the wire section on the new cable must not be less
2
than 1.0 mm (3 x 1.0 cable), keeping in mind that the end to be connected to the hob
must have the ground wire (yellow-green) longer by at least 20 mm. Use only
H05V2V2-F cable or similar which has a maximum temperature of 90°C. Any
replacement needed should be carried out by a specialised technician who should
make the mains connections according to the following diagram.
L = brown
N = blue
= yellow-green
The manufacturer will not be liable for any damage to persons or property cause
d
by non-observance of the above instructions or deriving from the tampering of even
a
single part of the hob.