Filter
Top Products
THEORY OF OPERATION
TO LIGHT STANDING PILOT:
1. Locate pilot adjustment screw. This is located between the burner valves and is accessable
through the slotted hole in the control panel.
2. Verify the gas supply line is connected and gas is being supplied to the unit.
3. Light pilot and verii that the pilot flame is approximately l/4 “ high.
4. If pilot is too low turn pilot adjustment screw counter clockwise to increase the pilot flame.
If
pilot is too high turn pilot adjustment screw clockwise to lower pilot flame.
A CAUTION
To
eliminate
aas buildup which could result in exolosion:
In the event of main burner ignition failure, a five minute purge period with gas controls in the “off”
position must be observed prior to restablishing ignition source.
A DANGER
EXPLOSION HAZARD
In the event a gas odor is detected, shut down equipment at the main shut off valve. Immediately call
the emergency phone number of your gas supplier.
A WARNING
BURN OR EXPLOSION HAZARD
Open burners must be installed a minimum of 16” from a deep fat fryer. Splatter of grease into an open
flame can result in fire. Splatter of water into grease can cause explosions and severe burns.
NOTE: Optional wok to be used on center ring burner Q&
PAGE 8