Southbend SPR-2 Range User Manual


 
I
NOTICE
I
I
Proper ventilation is the owner’s responsibility. Any problem due to improper ventilation will not be
covered by warranty.
I
A WARNING
I
improper ventilation can result in personal injury or death. Ventilation which fails to properly remove
flue products can cause headaches, drowsiness, nausea, or could result in death.
LEVELING:
Unit
must be level to assure maximum performance. Improper leveling may void warranty.
TO INSTALL STOCK POT RANGE:
1. Remove unit from packaging.
2. Shipped with every unit should be a leg package containing four legs. Two of which will have flanges for bolting
them to the floor. These legs are to be installed on the rear of the unit. These are labeled (Item “E”) in figure 1.
The other adjustable legs are to be installed on the front of the unit.
3. Leg pads (Item “C”) in figure 1 have already been installed on the bottom of the unit. To install legs simply screw
legs into leg pads on bottom of unit.
4. Once the unit has been moved into position adjust front and rear adjusters in bottom of legs until unit is level.
Make sure unit is leveled front to back and side to side. It is very important that this unit be level.
5. Once the unit has been leveled attach the flanged feet to the floor using appropriate fasteners.
NOTICE
This unit MUST be attached to the floor by means of the flanged feet at the rear of the unit. Failure to
do so may create a tip hazard which could result in injury to the operator or damage to the unit. Failure
to install properly will void the manufacturer’s warranty.
PAGE 5