Filter
Top Products
15
H. Install the spigots through the bottom of the front
door ( see Figure 18).
Figure 18. Front Door Assembly
I. Assemble the air bleed valve O-ring onto the air
bleed valves. Position the O-ring in groove close to
the wide part. Apply a thin film of sanitary lubricant to
the O-rings.
J. Insert the air bleed valves from the back of the front
door. Install compression springs onto air bleed
valves, then screw knobs on finger tight.
K. Apply a thin film of sanitary lubricant to the door seal
O-rings, and fit into the grooves on the rear of the
front door.
L. Place the front door assembly on the mounting studs
and push front door against the freezer carefully.
M. Secure front door assembly by placing the knobs on
the studs and alternately tighten opposite corners
until finger tight only. Do not overtighten. Proper
O-ring seal can be observed through the transparent
front door.
N. Move the spigot handles to the closed position.
G. Assemble O-rings onto the spigot dry, without
lubrication. Then apply a thin film of sanitary lubricant
to the outside of the O-rings and spigot bodies.