23
CLEANING COMBINATION UNITS
F
or Models 611, 611G, 650, 650G, 661, 642,
632, 685 and 695, it is possible to turn off one
section of your combination unit for an
e
xtended period without disrupting the other.
First, turn the unit off, then push and hold the
WARMER
key pad of the section you want to
disable. Then, turn the unit back on by
depressing the
UNIT ON/OFF
key pad. The
disabled section will be indicated with "--" in
the Control Center display panel. Repeat the
process to turn the section back on. See
Electronic Control System, page 12.
CLEANING THE ICE CHUTE
F
or Models 685 and 695, ice crescents may
occasionally become lodged in the ice chute.
The ice chute is a clear plastic housing that
d
irects ice from the freezer ice bucket to the
glasswell ice dispenser in the door.
To remove these obstructions, first remove the
adjacent shelves, then remove the screw in the
lower left corner of the side panel. Hold the
bottom of the side panel and push rearward,
then pull out. Once the panel is removed, the
ice chute will be visible. Refer to the illustra-
tion below.
To remove the side cover of the ice chute,
press the two side locking tabs, then pull up
and out. To reinstall, make sure the bottom
section of the ice chute is installed first. Then
fit the outside front cover lip inside the station-
ary portion. Finally, push the two assemblies
together and close the self-locking tabs.
Locking
Tab
Ice chute – Models 685 and 695
SUB-ZERO BUILT-IN USE & CARE