Filter
Top Products
24
FREEZER LIGHTING
F
reezer basket lighting is located below the ice
maker and mounted on the back wall of the
freezer. To remove the light shield, gently
c
ompress the shield to release the top, then
the bottom. The bulb is now accessible. To
reinstall the shield, put the bottom in place
first, then compress and insert the top. Refer to
the illustration below.
Models 611, 611G, 650 and 650G:
Freezer
lighting is in the top of the freezer, mounted to
the front of the evaporator cover. The bulbs
are accessible by opening the freezer drawer
and unscrewing the bulb from the top front of
the freezer.
Models 685 and 695:
Freezer lighting is acces-
sible above the ice bucket once the freezer
utility rack has been removed. See Ice Bucket
Removal, page 16.
Locking Clip
Light Shield
FREEZER
COLDER
WARMER
COLDER
WARMER
UNIT
ON/OFF
ON/OFF
ICE
ON/OFF
REFRIGERATOR
632
Light
Shield
Light shield removal Freezer basket lighting
SUB-ZERO BUILT-IN USE & CARE
LIGHTING INFORMATION
IMPORTANT NOTE:
When the refrigerator or
freezer doors are left open for a long time, the
l
ights may go off. This protects the internal
parts from overheating. To reset the light
system, close the door for 15 to 30 minutes.
Your Sub-Zero Built-In unit contains standard
4
0 watt appliance bulbs (part #3030030) in
refrigerator and freezer sections.
OVERHEAD LIGHTING
You’ll need to remove the light shield in the
top of the refrigerator or freezer to replace the
bulbs. Place your hands under the light shield
and release the two clips on the back of the
light shield, then lift up and slide back slowly
until the key slots on the side of the light
shield drop past the mounting studs in the side
walls. Then remove the shield. The bulbs are
now accessible. Refer to the illustration below.
Models 601RG, 611G and 650G:
Like all
Sub-Zero units, lights in glass door models will
fully illuminate when the door is open. With
the 601RG, 611G and 650G, however, you have
the option of having subdued lighting even
with the door closed. You can easily turn this
feature off by depressing the
LIGHT ON/OFF
key pad on the Control Center.
Shut off power at the control panel
before changing light bulbs. Wear protec-
tive gloves when handling bulbs.