Filter
Top Products
10
UNPACKING YOUR MICROWAVE
Remove all packing materials from inside
the oven cavity; however,
Do not remove
the waveguide cover,
which is located on
the top of the cavity, see illustration below.
Read enclosures and save this Use and
Care Information for future reference.
Remove the feature sticker (if there is one),
from the outside of the door.
Check the oven for any damage, such as
misaligned or bent door, damaged door
seals and sealing surfaces, broken or loose
door hinges and latches and dents inside
the cavity or on the door. If there is any
damage, do not operate the oven and
contact your dealer or Wolf authorized
service center.
WOLF CONVECTION MICROWAVE INSTALLATION
CHOOSING A LOCATION
FREE-STANDING
You will use the oven frequently so plan its
location for ease of use. It’s wise, if possible, to
have counter space on at least one side of the
oven. Allow at least two inches (5 cm) on the
sides, top and at the rear of the oven for air
circulation.
BUILT-IN
Your microwave oven can be built into a
cabinet or wall by itself or can be used above
any Wolf electric built-in oven.
Refer to the installation instructions in both the
built-in oven and Wolf’s Convection Microwave
Trim Kit.
Do not install above any other gas
or electric built-in oven.
The trim kit includes
finish trim strips, ducts, installation instruc-
tions and information on the location of the
power supply. To request the trim kit, contact
your dealer. Be certain to check the local
building code as it may require the opening be
enclosed with sides, ceiling and rear partition.
The proper functioning of the oven does not
require the enclosure.
Safety
door
latches
Hinges
Door seals and sealing surfaces
Waveguide cover