Filter
Top Products
5
Assembling Your Oskar
®
Food Processor
Using Continuous Flow Cover:
Set up the motor base facing you on a dry,
level surface with the tallest side of the
motor housing to the rear.
Place the clear Processing Container over the
drive shaft on the motor base. Lock into place
.
Place the ejector disc into the container by
holding the stem and placing the disc over
the drive shaft. Allow it to drop into place.
For slicing, hold the slicer/shredder disc with
the raised, curved slicing edge facing upwards.
Place the disc over the ejector disc and allow it
to drop into position.
For shredding, turn the disc over so that
shredding notches are facing upwards.
Place the disc over the ejector disc and
allow it to drop into position.
To attach the cover, place it onto the container
so that the pin in the cover fits into the hole at
the top of the ejector disc. The large locking tab
on the lid is to the right-hand side, near the
horizontal slot on the motor housing: when
turned counterclockwise, the tab will engage
the automatic switch and the OSKAR
®
Food
Processor will turn ON. Turn the cover in the
opposite direction to turn it OFF.
Note: Keep fingers away from the Continuous
Flow Chute when the OSKAR
®
Food Processor
is operating.