Filter
Top Products
8
Heading
Using your Kettle BBQ (continued)
Using your Kettle BBQ.
1. Insert the Heat Control Probe fully into the
socket of the hotplate.
2. Plug the cord into a 230-240 volt
power outlet and turn the power on. An
extension cord that has been checked
and tested by your electricity supplier or
a qualified technician may be used with
your Kettle BBQ.
3. Set the control probe dial to the desired
heat setting.
Remove the lid from the Kettle BBQ and
allow to heat up. When the thermostat
light on the control probe switches off,
the desired cooking temperature has been
reached and the Kettle BBQ is ready to
use.
For oven style cooking, set the dial to
Super Sear setting, replace the lid and
pre-heat for approximately 10 minutes.
Note: The thermostat light on the control
probe indicates the Kettle BBQ is heating.
This light will remain ON until the set
temperature has been reached and then
will cycle ON and OFF throughout cooking.
This will ensure that the Kettle BBQ always
maintains the selected temperature. The
pre-heat time will depend on the heat setting
selected.