Filter
Top Products
4
Features of your StickMaster Stick Blender (continued)
Wall mounting feature
If mounting the charging stand on a wall,
please follow procedure below:
WARNING: Always ensure you are not drilling
into the wall adjacent to any electrical wires or
pipes such as water or gas.
Do not mount the charging stand over or near
any portion of a heating or cooking appliance or
a sink or basin.
Template, screws and wall plugs are provided.
1. Find a suitable position on the wall or
cupboard where the stick blender is to be
positioned. When selecting a mounting
location, be sure to leave enough room
above the charging stand for your hand to
remove the stick blender parts.
2. Mark the wall with a pencil on the three
fixing points using the template provided.
Either
3.1 If fixing to a solid brick or block wall use
a suitable size masonry drill and drill to a
depth of 25mm. See figure 1.1
Insert wall plugs, then screw the screws
provided until the thread is hidden.
See figure 1.2.
The screw head should be protruding by
approximately 5mm to allow the charging
stand to hang. See figure 1.3
06mm
Figure 1.1
Figure 1.2
Wall
5mm
Figure 1.3