Filter
Top Products
General 5 Information
BE SURE ALL SURFACE ELEMENT CONTROL KNOBS ARE TURNED TO OFF “ ”
AND ELEMENTS ARE COOL.
Do not turn the oven light on during the self-cleaning cycle.
High temperature will reduce lamp life.
To level the range:
1. Use a 1-1/4” open end key or an adjustable wrench to equally unscrew the four leveling legs two to
three turns each.
2. Install an oven rack in the center of the oven.
3. Move the range to its final position, then put a spirit level on the rack to check for levelness. Take two
readings, one with the level placed diagonally first in one direction, and then the other.
4. Use the 1-1/4” key or wrench to adjust the leveling legs. Turn each one until the range stands firm
without wobbling.
5. Some models are supported by smooth glide rollers to facilitate moving.
If floor is flat and level, open the drawer and lower the front roller locking levers (some models) to
prevent the range from moving.
If floor is not flat or level or if this model has rollers without locking levers, use the 4 leveling legs to
level, support and prevent the range from moving.
Installation Instructions (continued)
LOCKING THE FRONT ROLLERS
(some of the 30” models only)
LOCK
UNLOCK
Oven Light
On some models an interior oven light will turn on automatically when the oven door is opened.
The oven light may be turned on when the door is closed by using the oven light switch located on or
underneath the control panel.
On a self clean oven the lamp is covered with a glass shield held in place by a wire holder.
THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE OVEN IS COOL.
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 watt appliance bulb only.
4. For self-cleaning oven, press wire holder to one side to release glass shield, change bulb and be sure
to replace glass shield.
Surface Light
(some models)
Use switch located on or underneath the control panel to turn the surface light ON/OFF.
Replace the surface light, if after repeated attempts to turn it on you are not successful.
SURFACE LIGHT REPLACEMENT (some models)
To remove and replace the fluorescent light:
1. Place your fingers under the tube at approx. 20.3 cm (8”) from each end.
2. To remove, turn the tube 90° then pull it down and out of its sockets.
3. To replace the tube, engage the new tube into the sockets, then rotate and snap the tube in place.
Turn on the surface light to make sure it will lit.