Filter
Top Products
Cleaning the Appliance
Exterior Cleaning
Clean range after each use to prevent sticky grease built-up and spills from cooking on. Wash with hot, soapy water and a clean cloth. Wipe
with a soft cloth or paper towel.
Do not use abrasives, steel wool, cleaners containing ammonia, acids or commercial oven cleaners on any exterior parts of the range, except
the porcelain enamel cooktop. If a metal cleaner or polish is used on metal trim, be sure the label specifies that it is safe for use on chrome
and aluminium.
Control Panel
Control knobs
If the control panel needs cleaning turn the control knobs to OFF “
”, then pull knobs straight off the
shafts.
Most cleaning of your steel/aluminum control panel can be done using a clean cloth with warm soapy
water or other mild household cleaners.
Sometimes, applying few drops of a recommended cooktop cleaning/polishing creme (with silicone) will
remove any remaining soil and will leave a protective coating wich will keep your range looking like new.
Cooktop cleaning/polishing creme can be purchased through authorized service centers or major
department stores.
Coil Elements and Drip Bowls
Coil elements clean themselves when they are turned on.
Coil elements and drip bowls are removable and allow to
clean the drip bowls.
To remove a coil element, push against the front edge and lift element up and out.
To clean by hand, wash the drip bowls in hot sudsy water. For hard to remove spots, use a
nylon scrubber with soap. Rinse and dry while still warm.
Never immerse coil elements in water.
Before cleaning any part of the range, make sure all heating elements are turned
to OFF
“ ”
and are cool.
INSTRUCTIONS
Use a damp sponge or dampened soap pad,
rinse and dry.
Use a clean, soapy, dampened cloth or paper towel,
remove soil and dry. Do not use abrasive products.
CLEANING AGENTS
Mild cleaners or soap-filled steel
wool pads.
Hot, soapy water or cleaner
creme.
SURFACES
Porcelain Enamel
(Cooktop, Surface under
cooktop)
Insert – Control panel
Prior to cleaning the coil elements make sure
they are cold and that control knobs are turned
to OFF “ ”
.
Warning: Never leave covers on the coil ele-
ments as they could be permanently damaged if
coil is turned on by accident.
Coil Surface Elements
General 9 information