Filter
Top Products
Cleaning the Appliance (Continued)
What to Expect During Cleaning
While the oven is in operation, the oven heats to temperatures much higher than those used in normal cooking. Sounds of metal expansion
and contraction are normal. Odor is also normal as the food soil is being removed. Smoke may appear through the oven vent, located on the
top of the control panel.
If heavy spillovers are not wiped up before cleaning, they may flame and cause more smoke and odor than usual. This is normal and safe and
should not cause alarm. If available, use an exhaust fan during the self-cleaning cycle.
NOTE: A smoke eliminator in the oven vent converts most of the soil into a colourless vapor.
Setting the Controls for a Clean Cycle
For the setting of the clean cycle, refer to the section on the timer or Electronic oven control.
To Remove and Replace the Oven Door
1. Open the door fully.
2. Pull up the lock located on both hinge supports and engage them in the hook of the hinge levers. You may have to apply a little
downward pressure on the door to pull the locks fully over the hooks.
3. Grab the door by the sides, pull the bottom of the door up and toward you to disengage the hinge supports.
Keep pulling the bottom of the door toward you while rotating the top of the door toward the range to completely disengage the hinge
levers.
4. Proceed in reverse to re-install the door. Make sure the hinge supports are fully engaged before unlocking the hinge levers.
To Remove/Replace Storage Drawer (some models)
To Remove/Replace the Storage Drawer with Rollers
To Remove the Drawer
1. Pull the empty drawer out to the roller guide stop.
2. Tilt the drawer up and pull it out over the rollers.
To Replace the Drawer
1. Insert the rear end of the drawer into the opening.
2. Fit the drawer end rollers onto the guide rails.
3. Push the drawer in until it stops; lift to allow the rollers to clear the roller guide stop; push in.
To remove and replace decorative drawer front panel (some models)
1. To remove decorative front panel, insert fingers in top groove and pull out to disengage from
clips.
2. To replace, first align slots of decorative front panel with clips located at bottom of range and push
back into its original position.
Lock in normal
position
Lock engaged
for door removal
HINGE SLOT
Door removed
from the range
General 12 information
Storage
Drawer
Roller
Front Frame
Rails