Filter
Top Products
White-Westinghouse
Installation Instructions (continued)
To level the range:
1. Use a 1-1/4” open end key or an adjustable wrench to equally unscrew the four levelling legs two to
three turns each.
2. Install an oven rack in the center of the oven.
3. Move the range to its final position, then put a spirit level on the rack to check for levelness. Take
two readings, one with the level placed diagonally first in one direction, and then the other.
4. Use the 1-1/4” key or wrench to adjust the levelling legs. Turn each one until the range stands firm
without wobbling.
5. Some models are supported by smooth glide rollers to facilitate moving.
If floor is not flat or level, use the 4 levelling legs to level, support and prevent the range from
moving.
Oven Light (some models)
On some models an interior oven light will turn on automatically when the oven door is opened.
The oven light may be turned on when the door is closed by using the oven light switch located on or
underneath the control panel.
The lamp is covered with a glass shield held in place by a wire holder.
THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE OVEN IS COOL.
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 watt appliance bulb only.
4. Press wire holder to one side to release glass shield, change bulb and be sure to replace glass shield.
Surface Light (some models)
Use switch located on the control panel to turn the surface light ON/OFF.
Replace the surface light, if after repeated attempts to turn it on you are not successful.
SURFACE LIGHT REPLACEMENT (some models)
To remove and replace the fluorescent light:
1. Lift up the control panel cover.
2. Place your fingers on the tube at approx. 20.3 cm (8”) from each end.
3. To remove, turn the tube 90° then pull it out of its sockets.
4. To replace the tube, engage the new tube into the sockets, then rotate and snap the tube in place. Turn on the surface light to make
sure it will lit.
BE SURE ALL SURFACE ELEMENT CONTROL KNOBS ARE TURNED TO OFF “ ”
AND ELEMENTS ARE COOL.
Do not turn the oven light on during the self-cleaning cycle.
High temperature will reduce lamp life.
General 5 information