Filter
Top Products
14
Model 220Operating Procedures
T urn the bearing holder so the holes are aligned with
the holes in the valve body. Secure with the keeper pin.
Figure 15
Step 4
Install thefreezerdoor. Align the hole inthe cross bar
with the hole in either hinge, and insert the hinge pin.
The cross bar can b e assembled for either right or left
opening. Holding the freezer door firmly, position the
door onto the cross bar . Align the cross bar with the
opposite hinge and insert the remaining hinge pin.
Figure 16
Make sure the freezer door fits securely over the
freezing cylinder . With the door seated over the front
of the freezing cylinder, install the cross bar screw
assembly in the center of the freezer door through the
cross bar . Tighten securely.
Figure 17
Step 5
Align the holes in the cover cap assembly with the
holes on the freezer door. Secure with the keeper pin.
Figure 18
Step 6
Slide the rear drip tray into the hole in the left side
panel.
Figure 19