Filter
Top Products
25
Model 220 Troubleshooting Guide
Section 8 Troubleshooting Guide
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
1. Unit will not run in the
“AUTO” position.
a. Unit is unplugged. a. Plug in wall receptacle. -- --
b. Circuit breaker is off. b. Turn the breaker on. -- --
c. Unit is off on reset. c. Place control switch in the
“OFF” position. Press
reset button firmly. Place
control switch in the
“EJECT” position and
observe freezer’s
performance. Resume
normal operation.
10
2. P roduct is not freezing. a. Dirty condensers. a. Clean condensers
regularly.
23
b. The control switch is not in
the “AUTO” position.
b. Place the control switch in
the “AUTO” position.
18
c. On water cooled units,
inadequate water supply.
c. Check to be sure the
water is turned on. Check
hoses for leaks or kinks.
23
3. Dr ive shaft is stuck. a. Rounded corners on shaft,
drive socket, or both.
a. Replace the drive shaft,
drive socket, or both. Do
not lubricate the hex end
of the drive shaft. Contact
a service technician.
-- --
4. Walls of freezer cylinder
are scored.
a. Scraper blades were
improperly installed.
a. Install them properly. 12
5. Excessive mix leakage in
the rear drip tray.
a. Drive shaft seal is worn or
missing.
a. Install or replace the seal. 11
b. Inadequate lubrication of
drive shaft seal.
b. Lubricate properly. 11
c. Rear shell bearing is worn. c. Contact a service
technician.
-- --
d. The wrong type of
lubricant is being used.
d. Use Taylor Lube. -- --
6. B uzzer does not sound
when the freezer cycles
off.
(Note: the buzzer is an
optional feature.)
a. Buzzer is malfunctioning. a. Contact a service
technician.
-- --