Filter
Top Products
16
Operating Procedures Model 432
Step 7
Position the torque arm by inserting it through the slot
in the torque switch arm and down into the hole in the
torque rotor which protrudes from the door . Verify
proper installation by moving the torque rotor back and
forth to be sure it moves freely and easily.
Figure 18
Step 8
Install the front drip pans. Slide the long drip pans into
the holes in the front panel.
Figure 19
Step 9
Install the front drip tray and splash shield beneath the
door spouts.
Figure 20
Step 10
Lay the air/mix feed tube (optional) i n the bottom of the
mix hopper.
Figure 21
Repeat these steps for the other side of the unit.